$2 Camera/GPS Motorcycle mount…
I was looking for a GPS mount for a motorcycle and the only ‘good’ one I found was about $12 USD shipped, plastic and cheap looking. Being a cheap bastard I decided to spend ~$2 and 15 minutes building a simple mount for a Camera(GPS as soon as I get to the store again).
It’s not pretty, but it works and is much stronger than the massproduced plastic junk I’d wager.
Take a piece of 3/4″ Birch Flooring(Any wood may work, hard wood is less likely to break), and drill hole the size of handle bars in the center of it.
Then drill 3 holes vertical on the flooring, 2(Clamp holes) beside the 1st hole(as close as possible) and 1(GPS/Camera bolt) through the middle of the fist hole.
Counter sink as desired.
Then cut/shape the wood, with 1 cut down the middle through the 1st hole purpindicular to the last 3 holes.
Obviously I didn’t mesure(Except for bolt sizes) or try very hard with the one pictured, maybe next time.
no comments yet.
Pyramid Parts Fork Seals, inferior? »« Canada Sucks, Car Imports.